How to Propagate a Hoya From Cuttings, Step by Step

Root a hoya from a stem cutting: where to cut, water or moss, how long roots take, and why a single leaf will not grow into a vine.

By , founder of Palma, 25+ years growing plants
View saved
Hoya vine with round green leaves in a white pot

At a glance

Hoyas are patient plants, and so is propagating them. The steps below work for any hoya: carnosa, australis, rope or kerrii. The one catch is the leaf-only cutting, covered in its own section.

Before you start

Hands trimming a stem with pruning shears

Timing. Iowa State University Extension says early spring is the ideal time to take cuttings from houseplants, though most can be propagated at other times too (https://yardandgarden.extension.iastate.edu/how-to/how-propagate-houseplants-cuttings). Warm, bright months suit a cutting that has to grow new roots.

Gather: clean scissors or pruners, a jar or small pot, a light rooting medium (water, moist sphagnum moss, or a light mix with perlite), and a spot with bright, indirect light.

Mind the sap. UF/IFAS warns against letting sap from a cut stem drip onto furniture, so work over a towel (https://gardeningsolutions.ifas.ufl.edu/plants/houseplants/hoya/).

Set expectations. UF/IFAS calls rooting stem cuttings an easy way to make new hoya plants, and Iowa State lists Hoya carnosa among the houseplants best propagated by stem cuttings (https://yardandgarden.extension.iastate.edu/how-to/how-propagate-houseplants-stem-tip-cuttings). Some cuttings can still fail, so take two or three.

Step 1: Choose a healthy stem

Pick a vine with firm leaves and no spots. Look for a node, the slightly swollen joint where leaves attach. The Iowa State hoya page says to use a cutting with at least one or two nodes. Its general cutting page asks for at least two nodes, with at least one of them buried in the medium, and a stem 3 to 6 inches long. Missouri Extension suggests 4 to 6 inches (https://extension.missouri.edu/publications/g6560). When in doubt, take the longer stem with two nodes.

Avoid damaging the peduncles at the base of flowers (UF/IFAS). NC State says the flower spurs rebloom over several years, so do not cut them (https://plants.ces.ncsu.edu/plants/hoya-carnosa/).

Step 2: Cut and trim

Hand holding small snips beside a young plant in a dark pot

Cut just below a node with a sharp, clean blade (Missouri Extension). Remove the lowest leaves so you have bare node or nodes to root. Missouri says to strip the leaves from the lower half of the cutting, and Iowa State says to keep leaves out of the medium. Let the sap dry for a few minutes.

Step 3: Pick a rooting method

Cuttings rooting in small glass jars on a sunny windowsill

Iowa State lists three: water, moist sphagnum moss, or a light propagation mix.

Water. Easiest to watch. Put the node in water and keep the leaves above it. Iowa State says to change the water once or twice a week and keep the developing roots submerged.

Sphagnum moss. Keep it damp, not dripping. Pack it lightly around the node.

Light mix. Missouri Extension lists coarse sand, perlite, vermiculite and peat pellets as rooting media, or sand or perlite mixed with an equal volume of peat moss. It says not to use field soil.

Whichever you choose, keep the cutting in bright, indirect light.

Method What the sources say Watch for
Water Iowa State lists it for hoyas; change the water once or twice a week and keep new roots submerged Roots grown in water move to soil later
Sphagnum moss Iowa State lists moist sphagnum for hoyas Missouri says never let the medium dry out
Light mix (perlite, sand, peat) Iowa State lists a light propagation mix; Missouri names the media above Missouri says to keep humidity high throughout rooting

Step 4: Give it warmth and humidity

Close-up of a silver-splashed hoya leaf

Rooting goes better in a warm spot. Iowa State says to cover the cutting with a loose plastic bag or dome, propped up with chopsticks or wire so it does not touch the plant. Missouri Extension says the same thing in another way: seal the pot in a plastic bag and keep it out of direct sun. Open the bag now and then so air can move.

Step 5: Wait

Stem cutting with fine white roots growing in a clear glass bottle of water

Iowa State says roots on hoya cuttings often form within weeks, depending on warmth and light. For houseplant stem cuttings in general, Iowa State gives 3 to 6 weeks. Missouri Extension says rooting time varies greatly among plants and suggests checking occasionally by gently removing a cutting. New leaves may take longer.

What to expect, week by week

These timings are general ones for houseplant stem cuttings (Iowa State), not hoya-only figures.

1. Week 1. Keep the cutting warm, bright and humid, and keep the medium from drying out. 2. Weeks 3 to 6. Most houseplant stem cuttings root in this window. 3. When roots reach about 1 inch. Iowa State and Missouri Extension both say this is the time to pot up.

Step 6: Pot it up

Close-up of a rooted cutting with new white roots

When roots are about 1 inch long, plant the cutting in a chunky, fast-draining mix, such as potting soil with orchid bark and perlite or pumice. If you rooted in water, move it to soil gently.

Water it in, then let the mix dry almost completely before watering again. Keep it in bright, indirect light and skip fertilizer until you see new growth. Iowa State says to feed hoyas lightly in spring and summer only.

Special cases

Hoya kerrii (sweetheart)

A single heart-shaped leaf with no node will root but will not grow into a vine. Iowa State says leaf cuttings only grow into vines if a node is attached at the base. NC State says leaf-only cuttings of kerrii root poorly unless a bit of stem is attached (https://plants.ces.ncsu.edu/plants/hoya-kerrii/). If you want a kerrii that grows, take a stem cutting with a node. Our Hoya care guide covers the single-leaf plant in more detail: https://palmaplants.com/pages/hoya-guide

Hoya australis and rope hoya

Handle them the same way as the carnosa steps above. Iowa State says the rope hoya has the same care and flowering characteristics as the typical species and grows much more slowly, so expect a longer wait after rooting.

If your cutting is not doing well

The extension pages do not list hoya-specific rooting failures, so these checks come from what they do say.

  • The medium dried out. Missouri Extension says never to let the medium dry out during rooting.
  • The water is stale. Iowa State says to change water once or twice a week.
  • Leaves press against the bag. Iowa State says to prop the bag up so it does not touch the plant.
  • Nothing yet. Missouri says rooting time varies, so check by gently lifting the cutting before you give up on it.

After rooting

Three small plants in ribbed pink pots held in hands

A new plant may not flower for a while. NC State says most carnosa plants do not bloom until they are 2 to 3 years old. Give it bright light, let it dry between waterings, and resist the urge to repot into a big pot. Iowa State says hoyas flower better slightly potbound.

Care for the whole plant is in our guides: https://palmaplants.com/blogs/news/hoya-carnosa-care-how-to-get-hoya-to-bloom and https://palmaplants.com/pages/hoya-guide

FAQ

How do you propagate a hoya?

Take a stem cutting with one or two nodes, strip the lowest leaves, and root it in water, moist sphagnum or a light mix in warm, bright, indirect light. Roots often form within weeks.

Can you propagate a hoya from a leaf?

A leaf alone will root but not grow into a vine. The cutting needs a node (Iowa State).

How do I propagate hoya australis?

The same way: a stem cutting with a node, rooted in water or a light mix.

People Also Ask

How long do hoya cuttings take to root?

Often within weeks, depending on warmth and light (Iowa State). The general figure for houseplant stem cuttings is 3 to 6 weeks. New growth can take longer.

Is hoya easy to propagate?

Stem cuttings are the standard method. UF/IFAS calls rooting them an easy way to make new plants. Some cuttings can fail, so take a few.

Should I root a hoya in water or soil?

Water lets you watch roots; moss or a light mix keeps the cutting closer to a potting setup. Iowa State lists all three.

How do you root a rope hoya?

Use a stem cutting with a node. Iowa State says its care matches the typical species.

Hoyas at Palma

Written by

Nick Alan

Nick Alan is the founder of Palma and has grown plants for 25+ years. He writes the shop's care guides and built the watering, soil and light tools.

View author profile

Plants to grow next

Hoyas

Keep going with the care library

Care pages by plant, plus the watering and light calculators and the plant doctor.

More from the Journal

All Journal articles